How to get the ink off stardust carto?

[mylose64]

I really wasn't going to let this get to me, but the numbers on the side of the stardust cleoromizers are really annoying me. When I first saw the product I was immediately concerned with the aestetic of the stardust because it has a measuring system which is imprinted onto the clearomizer. I still purchased it and I love it, but the measurments are totally off and don't even make any sense. The guage starts below the metal part of stardust!

Anyone know how to get this ink or whatever it is off?

I love the design of the stardust, it's like a combination of the MAP tank and the ce2 clearos, but this measurement thing is kinda stupid!

 

[Caridwen]

I don't know Mr Fussy Pants.

Kidding- I don't get why it's on there either. How about some alcohol? Anything stronger might melt it. I know the printing on syringes comes off pretty easily with just soap and hot water when I wash them. Maybe try to just wash the outside?

 

[fray]

Dilute vinegar 1:5 with hot water and scrub. If you can soak a paper towel and let it sit on it for about 20 mins it helps. Works well for getting paint off of attys as well

Other than that you are looking at solvents like acetone which will evaporate but tend to give people the hebbie jeebies with something you are putting in your mouth

 

[Samyaza]

Nail varnish remover works well apparently

I'd wipe the outside off with warm water and a damp cloth before vaping

 

[Malduk]

This thread is relevant to my interests.

 

[Vchick]

I found that Purell (or any type of alchohol based hand sanitizer) removes marker from plastic (have stubborn writing on a dry erase board? ~ works wonders!)

I'd try a little bit with a q-tip, Let us know how you do! hth!