Hybrid Magneto RSST, how to disassemble tank?

[ForeverDiving]

Hi folks! I have a hybrid type RSST for my smok Magneto mod (like this here... plagiarizing photos from the web). It jumped from my hand and cracked the pyrex tank.

Found a suitable PMMA one but I cannot disassemble it! Can anybody tell me how it is done or point me to a tuto? It seems just pressed in but I cannot find how to separete the two SS top & bottom sections.

Thanks for any help.

 

[PaulBHC]

Check the pictures here

Magneto RSST RBA - Kidney Puncher

Looks like you take the nuts off, then unscrew the deck section.

 

[crxess]

Unscrew center pin/post and remove
Unscrew top section
Lift out glass section

 

[ForeverDiving]

Million thanks, Bad & Xcess! Actually I got it from KP but somehow (stupidity or old age?) I completely missed the pics there. OK, so I was doing it right and it's just stuck! ¡Demonios! I was afraid to finish breaking the glass tube and end up with a dosen small pieces so maybe I was not applying enough force —I need it in one piece to make a SS clone. I'll tape it with some duct tape and put it in a nylon jawed vise.