I Clear 30 problems???

Status
Not open for further replies.

niko69

Senior Member
ECF Veteran
Dec 16, 2010
88
15
NYC
Just got my MVP 2 few days ago and was very happy, but today my I Clear 30 seems not to be working anymore? I read somewhere that people had problems with it, but after doing search couldn't find that post.

When I draw there is no vapor, i clear seems dead. When I press 2 buttons together on my mvp 2 it shows no Ohm's reading as the topper is not attached to it at all?

Is there a fix for this problem?


Thanks...
 

Jayvaps

Super Member
ECF Veteran
Verified Member
Sep 22, 2013
614
864
South Florida
Sounds like a center pin issue to me. Although it could be the head on the iclear.

First make sure the center post INSIDE the iclear is on nice and snug and not loose. If it is still not reading it, and you have replacement heads, try that.

But again, it sounds like a center post problem, either the mvp well is too deep(I have seen innokin products with very deep wells on their 510 connections) or the center pin connection of the iclear is too high.

You can try GENTLY pulling down on the pin in the iclear, or GENTLY pulling up on the center pin on the MVP with a small crewdriver or paper clip. Basically, you are trying to wiggle it just a bit.

Center Pin Issue - Fixing a non firing eGo battery - YouTube
 

Daryl Glen

Super Member
ECF Veteran
Sep 23, 2013
326
245
Titusville, FL, USA
www.youtube.com
Same thing happened to me, and the actual head was unscrewed a little bit. When you take the top cap off to re-fill your juice, sometimes the motion of taking off your top cap will unscrew the head a little bit.
Make sure that the head (the part with the wicks on it) is screwed snug down on the post.
Try it again.
If not, then the coil may be dead as mentioned above.
Hope that helps!
 

niko69

Senior Member
ECF Veteran
Dec 16, 2010
88
15
NYC
Same thing happened to me, and the actual head was unscrewed a little bit. When you take the top cap off to re-fill your juice, sometimes the motion of taking off your top cap will unscrew the head a little bit.
Make sure that the head (the part with the wicks on it) is screwed snug down on the post.
Try it again.
If not, then the coil may be dead as mentioned above.
Hope that helps!



Yeah, I think this was it...screwed the head a little and moved the center pin upward and now it works...thanks y'all...
 

Aviz

Super Member
ECF Veteran
Verified Member
Dec 24, 2013
409
188
SF E. Bay , CA
(to help ppl for whom the above did not work:)

I had the above issue AND the outer circle did not connect as well. (it worked on iTaste VV3 but not on perfectly good eGos). so I pulled the pins - still nothing - then I adjusted the "beauty ring". that fixed the negative contact and it works. .. so if you ever use an eGo - the beauty rings are not just for beauty.
 
Status
Not open for further replies.

Users who are viewing this thread