I am looking at this tank cartridge. Now from what I've read about this, I assumed that I would have to puncture a hole in this thing with the atomizer. These cartridges came with a soft rubber cap and already have a hole in them. I don't want to make a big mess here and I am unsure how to proceed. Please advise, 'cause I is a noob!
- Status
Not necessary to buy another piece of hardware. The OP just had a question, not a complaint.
I'm not familiar with the eGot-T, just seen a bunch of videos on YT. Once the tank is full, you just push it into the top of the atomizer until it snaps. That snap will punch a hole in the bottom of the tank. Give it a bit to let the juice flow into the atomizer and vape away. If you didn't get a manual, try this.
How to use the eGo-T Electronic Cigarette, and general information - YouTube
There you go, that should help.
There you go, that should help.
Yeah no need to poke any holes, they made one for you already!!! eGo-T is a tremendous starter system, it got me to quit. Fill the tank, slide it in and line it up with the atomizer slots with the tank groves, and vape. The soft caps are better than the hard caps for leaking, just take the end of a fork to remove and refill. Good luck!
Thanks. I just filled it through the pre-made hole and with minimal spillage managed to get it put together. This may take some getting used to.
Thanks. I just filled it through the pre-made hole and with minimal spillage managed to get it put together. This may take some getting used to.
Pop the soft cap off with a fork end, then fill. You can fill through the hole with a syringe but the soft cap is pretty easy to get off. You'll get the hang of it.
I just ordered one Friday. Waiting impatiently for it to come in. I was using the mystic e-cig and wanted to upgrade. Anyways i found this thread very helpful, Thanks and good luck.
Loved it at first. After the first tank cartridge was done, I realized I would need a larger tank. This 2011 technology was state of the art when it first came out, and still an attractive, polished setup today. Great starting place, and the batteries will be with you for a long time. I still have mine.
billbeckusa:10352346 said:
Indubitably those batteries are still decent and will work for most attatchments. Make sure you get some spare atomizers if that is going to be your go to setup, they burn out quick and you can't really recoil them. You can change the wick and get another day or two out of it, but its a pita.
I found keeping the atomizers dedicated to one set of flavors (fruit in one and sweet/coffee in the other), made mine last. I got a month+ out of my first two atomizers and one still works fine. When I started to get a burnt taste, I blew it out through the atomizer top through the battery connection, then soaked it in alcohol/water. Let it sit overnight and the next day it was fine.
The vv Joyetech 650mAh batteries that came with it are awesome, love them. I like them so much in fact, I see no reason to buy any mod beyond the itaste mvp for now. I have one 1100mAh vv battery, three 650mAh vv, and one 350mAh.
The eGo-T tanks are a great vape but I just couldn't take the leaking. I think the flavor and cape are good though, just think the EVOD BCC tanks on top of the Joyetech batteries is a slightly better set-up for those coming from cig-a-likes.
The vv Joyetech 650mAh batteries that came with it are awesome, love them. I like them so much in fact, I see no reason to buy any mod beyond the itaste mvp for now. I have one 1100mAh vv battery, three 650mAh vv, and one 350mAh.
The eGo-T tanks are a great vape but I just couldn't take the leaking. I think the flavor and cape are good though, just think the EVOD BCC tanks on top of the Joyetech batteries is a slightly better set-up for those coming from cig-a-likes.
- Status
Similar threads
- Locked
- Locked
- Locked
