I need help identifying an o-ring from my kayfun 3.1

[twolostminds]

I just got done cleaning my kayfun 3.1 and after putting it back together it I noticed a tiny o-ring sitting on the table and I have no idea where it goes :-(
At first I thought it was the chimney raining but its too small can anyone help me?

Sent from my One using Tapatalk

 

[twolostminds]

Here is a picture of the o-ring next to an 18g blunt tip needle.

 

[State O' Flux]

Unless it was being used to space the 510 screw downward... it appears too small for any other position.

 

[twolostminds]

Unless it was being used to space the 510 screw downward... it appears too small for any other position.

I didn't even think to look at the screw :: Seems that was where it came from. My SS polished hcigar kayfun 3.1 doesn't have an o-ring there but without it my matte 3.1's screw doesn't sit flush. Thanks for the Help.

 

[Rat2chat2]

http://http://vapercoils.com/kayfun-3-1-repalcement-o-ring-sizes

Does this help any? Hope so. Good luck to ya.

 

[State O' Flux]

I didn't even think to look at the screw :: Seems that was where it came from. My SS polished HCigar Kayfun 3.1 doesn't have an o-ring there but without it my matte 3.1's screw doesn't sit flush. Thanks for the Help.

No problem. Sometimes I'll use 1.5 or 2mm ID o-rings for spacing threaded 510 screws down... to obtain best fit/contact.

Cheers

 

[Jdbaker82]

I just got a 3.1 ES from angelcigs it's a ivogo and man for $25 this thing is well build and works perfectly!!!

Sent from my SCH-I545 using Xparent Skyblue Tapatalk 2