Well I finally did it. I made a I06 tank to see what all the hubbub was about. I used a 3.5 ohm L06 mainly because it was the only one I have left. It doesn't put out as much vapor as my beloved fusions do but what does? I imagine that's because it's a 3.5 ohm and the highest setting I had on the PV was 5.5 volts. But it did have enough vapor. About the same as a 510 does the funny part was I will have to use it after I reduce my nic level because it did knock me for a loop. Couple puffs off of it and I'm dizzy as I care to be. It works good though. Now I'm going to have to get a 2.5 ohm and put one together or lower my nic.
I06 Tank
- Thread starter 5cardstud
- Start date
- th_trl_thread_readers 0
- Status
You know I'm rocking I06s over anything else!!!
Although they are the best atty I have ever used, attys in general are too much work for me. I'm a die hard Fusion vaper.
I guess that's pretty well known. I even made my own emoticon because of my fusion addiction.
I got that figured out. Now I need to get a lower resistance one than this 3.5 Ohm. It's working a lot better now but 24mg. is just to high for this contraption. One puff and I can feel it. I bet that RY4 tastes good in it.
Last edited:
OK, where do I find out how to do this?
http://www.e-cigarette-forum.com/forum/ikenvape/250953-ripples-i06-tank-sleeve-mod.html
I used a tubing cutter but I replaced the blade with a thin washes and it crimped it down real good. I did it on 2 spots. The juice sure has a different flavor and it's working better or I am.
Edit: What would be nice is if we could get Isaac to make a version of the I06 with a tube attached but probably not that many people using them.
Edit: What would be nice is if we could get Isaac to make a version of the I06 with a tube attached but probably not that many people using them.
Last edited:
Well to be honest my blade was MIA so I used the washer.My cutter's blades are dull.........
I changed it and it's a lot better. I put it in my tank backwards and the screw in the tank filler port goes right over the hole in the I06 so I can adjust the flow from the tank to the I06. Works darn good like that. The hole was tiny anyway but still let to much juice into it IMHO.
I got RY4 in it right now and loving it but I still need to lower the nic level.
Last edited:
- Status
