Iatty

[Grant1]

Hi Chap's
When you fill an Iatty with juice, how far can you fill it up when your looking into the top, is it ok to have filled it over the wick cover cone, or where should the top level of juice be when it is classed as full please??
All the best
Grant

 

[gredie]

I fill the iatty up to 1-2mm below the top of the tank most of the times. Just be sure to have the cone (nearly) closed before filling. I also close the airflow control when i use the iatty on the GGTS.

 

[Grant1]

I fill the iatty up to 1-2mm below the top of the tank most of the times. Just be sure to have the cone (nearly) closed before filling. I also close the airflow control when i use the iatty on the GGTS.

Out of interest Gredie, once you have filled then, what do you then do with the cone, the Iatty is new to me and I am using in sealth mode so no air control, does the cone control the air or the juice??, I have been being causious and not fillled above the cone,only up to it,

 

[gredie]

The cone is for juice control, the more you open/unscrew it the more juice comes to the wick/coil.
I'm not really sure what you mean, the upper end of the cone is a bit higher than the tankbody without cap. So you can fill the tank full and then screw the top cap and then mouthpiece on.

 

[Grant1]

What I was meaning was this.... you screw the cone nearly closed and then fill, then do you open the cone, if you do why would you close it for filling, because once full you open it so the closing procedure would achieve nothing, or do you trying it first untill you dont taste burning or>>>,,...... Im just not si=ure of the procedure after it is slightly open then filled then .. what next to set up correctly?? please and thank you.

 

[fright88]

I didnt close my juice controll when filling my iAtty 1. I never had leaking issues except when I let it sit overnight and then it was only a couple drops through the center post.

 

[dspin]

Out of interest Gredie, once you have filled then, what do you then do with the cone, the Iatty is new to me and I am using in sealth mode so no air control, does the cone control the air or the juice??, I have been being causious and not fillled above the cone,only up to it,

People that did not have a TS for air control were putting an oring at the bottom of iatty to tighten the draw.

 

[Grant1]

Many thanks Chaps for all your answers
Grant