So I have an iclear 30 and it's getting really hard to pull from, almost as if it's clogged. I've taken it apart, cleaned it, and tried again however it's still really difficult to pull from.
Any ideas?!
Any ideas?!
Iclear 30 hard to pull
- Thread starter Nick.G
- Start date
- th_trl_thread_readers 0
- Status
A little less than a month, wicks look fine. I did the regular run down, washed it out, let it soak a little bit, did the dry burn. Might not have let the dry burn go long enough though.
On dry burn, pulse the coil until there is no more smoke and it burns bright red. Dont hold the power to it too long though. Rinse it well again in hot water to removed the ash. Dry burn again.
Just under a month is good time for these coils/wicks. It may just be time to change it out. Sometimes the wicks just get "tired" and cant be revived any longer.
Sent from my couch using Tapatalk.
Just under a month is good time for these coils/wicks. It may just be time to change it out. Sometimes the wicks just get "tired" and cant be revived any longer.
Sent from my couch using Tapatalk.
Yea I'll give it one more clean let it sit and try again. Thank you!
I found that if I put a tad too much juice in it, it's impossible to draw from. Try removing a bit of the juice.
Yep, agree that over filling can cause problems, fill it to a tad below the silicone top over the wicks. Also agree that a month is a good time to just put in a new coil. The ones for the IClear 30 are really cheap if you get them online.
I've received quite a few bad coils with my iClear 30s...
Too much juice can do it as well.
Prime it and you should be good to go!
Let it sit for about 20 min as well to let the wicks
Too much juice can do it as well.
Prime it and you should be good to go!
Let it sit for about 20 min as well to let the wicks
- Status
Similar threads
