iclear 30 recoil

[mad maori]

has anyone figured out how to recoil these? the bottom pin comes out, the top coil has wires that go into a sleave that connect to the coil below? do i just recoil both and connect? do i have to use non resistance wire to make connection between coils?? i know the heads are cheap enough to buy, but i wanna figure out how to do it myself just for the heck of it.. any one done it with success?????? any videos on it???

 

[mad maori]

no answers!!! oh well ill give it a go using kiwi no.8 fencing wire ingenuity!!! hope i don't fry my lips off!!!!!!!

 

[chimsweep]

Love the Iclear 16 that I picked up and lost to the wife as soon as I got home from the vape store......so I loved it on the way home. Don't have any answers for you. Hopefully DAM718 will be doing a vid on this very subject. I know he has done the Kang T3's. How To: Fix your leaking Kanger T3! - YouTube

 

[mad maori]

cool- i figured out how to re-coil the t-3 its exactly like the vivi nova except less space to work in.. lucky cause i almost threw them in the bin after leaky tank and dry hits.... i used 3mm wick and 32g kanthal, cut the wick a fraction longer than the factory one and fluffed it up, got 1.9 ohm -- man im loving it!!!! better than the nova now!!!! almost finished a tank and not one dry hit, no leaks so far and taste is good!!!!!

 

[mad maori]

ohh- and i ditched the rubber grommet, not the one that the pin goes into but the one on the post-dosnt seem to leak and im on 2nd tank!!!!!

 

[Flyer]

According to some who have tried, the iClears use resistance and non-resistance wire in a very confined space. If so, may not be practical for most of us to try. Bet they would be good with the bamboo wicks I use in Vivi Nova rebuilds.