Judging by the igo-s dripper I'm using on another mod, I'm expecting great things from this. I use 30g Kanthal, 7 wraps for about 1.3Ω, with a cotton yarn wick, and get great flavor, and plenty of vapor. Oh Boy! Can't wait to try the -s b/f.
igo-s bf has shipped
- Thread starter oplholik
- Start date
- th_trl_thread_readers 0
- Status
Is there a picture outhere somewhere with a new Rob igo-s next to a Rm2 for size and profile comparison?
Received the igo-s bf today. Gave it a cleaning, then installed a coil and wick, and squonked it before putting the cap on just to see it working. I gotta say, this little baby works quite well. It is, of course, what you make it with your coil and wick. So if you use smaller builds this is excellent, and you can save a few $ to boot. 
Is it just me or does that look like it would be an easy dual coil set up. Like maybe one coil on each side of the posts. Also OP is the igo-s milled to fit the Reo like the RM2?
Last edited:
You could do dual micros, or just a lower ohm single. I tried a tiger coil, which I believe counts as dual...meh.
It's not milled, but it fits my grands and my 2.1 like it was made for them.
Received the igo-s bf today. Gave it a cleaning, then installed a coil and wick, and squonked it before putting the cap on just to see it working. I gotta say, this little baby works quite well. It is, of course, what you make it with your coil and wick. So if you use smaller builds this is excellent, and you can save a few $ to boot.
That's good to hear. I'm happy it worked out for you.
- Status
Similar threads
- Locked
- Locked
