IGO-W and Kayfun Lite question

[thirtyfour41]

Thanks everyone for the advice. I threw together a quick coil last night, I had a little free time. It was total crap, admittedly, but it did work. Came to about 2.4 ohms on a single coil with 32g. Wrapped the cotton around the coil since I've not yet mastered the art of threading it through. Tonight, I am going to try again, maybe with different wicks and gauges of kanthal, just to see what results I get. I decided, too, that I'm only going to drill out one hole on the IGO, and like somebody above mentioned, I can always drill out a second later.

 

[MonicaRae]

Weird your Igo-W only came with 1 airhole. Theyre supposed to have 2. But still even with 2 it's tight. I'm like you I have no way of getting them drilled - lucky you have a B&M.

I'm wondering how you wrapped the cotton around the coil? To thread it thru just roll it up with ur fingers till its long & thin then thread it thru..snip off ends. Use less than you think you need (I still use too much half the time)

 

[thirtyfour41]

Weird your Igo-W only came with 1 airhole. Theyre supposed to have 2. But still even with 2 it's tight. I'm like you I have no way of getting them drilled - lucky you have a B&M.

I'm wondering how you wrapped the cotton around the coil? To thread it thru just roll it up with ur fingers till its long & thin then thread it thru..snip off ends. Use less than you think you need (I still use too much half the time)

It's an IGO clone from Fasttech, so that's why it only came with 1 air hole.

I wrapped the cotton like this: An Illustrated Guide to Coiling an IGO-W - Vape Core

Seems to work ok, cotton dries out pretty quick though as it gets dry right in the middle. Like I said, I think I'm gonna try different wicks tonight and see how they works out.

 

[retired1]

Moved to Rebuildable Atomizer Systems

 

[thirtyfour41]

Moved to Rebuildable Atomizer Systems

I have a Kayfun I'm building, too.

 

[Juiceinator]

you are using a regulated mod not a mech, stick to 1 1/16 hole and try a 1.5ohms microcoil and cotton, that works wonders on a regulated mod, DON'T drill a second one just yet it is easier to drill another one down the road than to block one

Thats the truth. I did my math incorrect(highly uncommon for me)And drilled my igo with a 3/32 which for some it's perfect. For me it's way too airy of a draw for me and i don't like it. I'm running a dual micro which I love on a mech but it's just turned me off to rdas now. I just prefer my agat+ i have no idea how to make the air flow adjustable so I'm left with either buying a new cap for my igo or sticking it out and hoping i like it more down the line.

 

[Juiceinator]

Take the cotton make a thin wick and thread it through a sewing needle. Run the needle through the doesn't get easier