IGO-W single coil trouble

[PoeDung]

Hi,
I got my 1st rda, the IGO-W, today and am having trouble with building micro coils. I'm using 30 gauge Kanthal with 10 wraps around a 1/16 screw driver. It lights up evenly, and I can get a few good draws, but after that nothing. I'm using organic cotton & am remembering to put more drops in.

I really haven't been able to find a you tube video for micro coils that's NOT sub ohms. I'm trying to build a 1.8ish ohm coil & have no issues with a Protank build.

Anyone got any suggestions?

 

[desk1%]

What are you firing on? Mech? VV? VW? The other thing I have happen is that the contact screws will loosen up a bit after installing a new coil. Also a micro coil is a contact coil so make sure that you're coil is contacting itself evenly. If you don't have a meter to gain an accurate ohm reading abandon project until you have acquired said tool.

 

[PoeDung]

I'm using an iTaste MVP 2.

 

[desk1%]

From what I understand about VV/VW devices you really need to keep your coils at or above 2 ohms. The whole reason to adjust resistance is to change the wattage. With the device you're using you can execute the same function all the way up to 4 ohms. Try a few more wraps and see if that solves your problem.

 

[MamaTried]

this contains a link to a helpful spreadsheet
http://www.e-cigarette-forum.com/fo...o-coils-ohms-description-15.html#post11417089

you can find examples for most resistances people use

 

[classwife]

Moved to Rebuildable Atomizer Systems from The Modding Forum - Atomizer Mods

 

[PoeDung]

Got it working! Definitely need to drill out those holes, can see what people were saying about a tight draw.