IKV i06 atty, What drip tip fits?

[carlton M]

Love the i06 atty from Ikenvape, but hate the drip tip they have for it, it is too narrow, and the juice does not flow down to the atty easily, so I got a Cannon DT.
The i06 is too big, and the Cannon wont fit, so what drip tip will fit the i06?

What other GOOD atties will fit in the Cannon DT?

 

[ukeman]

you can try lifting the i06 d/t off and drip on the coil and in the well.
They dont hold much juice and they vape it off fast, so that's a chore, but it gives the best vape.

Please email John at Theecig.com and ask for a d/t for the i06!
He said he is thinking about it... imo pyrex d/t's are essential for good dripping, and so is the i06!

 

[carlton M]

When there's a will there's a way...
I heated an awl and reamed it into the hole on the the mouth piece end of the i06 DT a couple of times, and melted the inside-widening it where the juice was catching, sanded it a bit and viola! No more vapor lock, no more juice (EEK!) in my mouth!

 

[carlton M]

Cisco spec 306 1.8 ohm atty (from Avid Vaper) with the Cannon DT, on my BB with 14650 extension tube + Bounty Hunter (NLV)= BLISS!

 

[makasin]

Hmm so I have had the i06 before and both of mine just died. Has anyone had major primer issues with these atties? I seem to be unable to get rid of the primer in those, they seem especially difficult to clean for some reason. I basically tried to vape it all out by not inhaling but that took almost a week and once it finally went away, I only got 2 days of vaping before it died. This was my error, I shorted it out and killed it. But regardless, anybody have the problem with primer?