I'm so HAPPY! voltage/wattage for MVP 2.0 question

[Emzie Blankenship]

I just received my MVP 2.0 in the mail, I AM IN LOVE. I can't express my happiness at the moment. It's like.. AJFNASKJLDFNASKJDFN so happy. Although I had a question about it!

It has the iClear 30 tank.

What voltage/wattage do you all prefer to run on the iClear 30? I do not know anything about subohming or anything like that, so what is the recommended voltage/wattage for the iClear 30?

 

[steved5600]

I would not go over 16 watts. Iclears don't come subohm yet. Assuming a 1.5 ohm head that would be just under 5 volts. If you exceed that voltage i bet you will outrun that wick which on them is a top feed. If you had the 2.1 ohm head the voltage would be a little under 6 volts. But really you should just adjust it to get the amount of vapor you want and the taste you want. Going to high will likely give you some th and dry hits.

 

[DavidOck]

Just pick your mode - VV OR VW. Set it to the lowest setting, vape. Not enough? Go up a step. vape. Repeat until the flavor starts to taste "off" and back off a step or two.

The "final" setting, where you're happy with the flavor, may be different for different juices, so no specific setting is right all the time. And tastes vary, so no one setting is right for everyone anyway. Which is, of course, one of the best things about variable power sources, you can fine tune to your preference.

By starting low, you can avoid the dry hits Steve mentions.