Innokin iSub G pg/vg ratio and usage
- Thread starter Brady Mandile
- Start date
- th_trl_thread_readers 0
- Status
I have a few atomizers. You'd need more than 5 people to count how many on their fingers.
In the old days, high VG was a problem. Even 70% VG could be too much. These days, if you use between 50/50 and 70/30 VG it's hard to go wrong. Subohm tanks can get spitty using 50% PG which is why I mix to about 60-65% VG.
I would avoid full VG and not order too much 50/50 while getting used to this tank. Personally, I'd just buy 70/30 VG as a starting place.
In the old days, high VG was a problem. Even 70% VG could be too much. These days, if you use between 50/50 and 70/30 VG it's hard to go wrong. Subohm tanks can get spitty using 50% PG which is why I mix to about 60-65% VG.
I would avoid full VG and not order too much 50/50 while getting used to this tank. Personally, I'd just buy 70/30 VG as a starting place.
Me I like max VG as PG just makes me cough. From what I've read folks have had mixed results with high VG with that tank. I've read some poke holes in the cotton with a pin, someone else mentioned filing the RBA's holes wider, but most folks simply set their power lower and/or avoid chain vaping.
Of course you could always steer clear of high VG or buy a different tank.
Of course you could always steer clear of high VG or buy a different tank.
- Status
Similar threads
