Innokin itaste mvp 2.0 and Protank 3

[Archer]

My MVP and Protank 3 aren't getting along. Anyone know why I keep getting "non" on the mvp? and how to fix it?

Thanks,
Archer

 

[CreepyLady]

The pin in the bottom of the protank probably needs a teeny weeny pull with tweezers. Like [] <<< not even that much.

The MVP has a really deep well and once in a while a protank or evod needs a tiny bit of tinkering to make contact.

 

[smacuser]

The pin in the bottom of the protank probably needs a teeny weeny pull with tweezers. Like [] <<< not even that much.

The MVP has a really deep well and once in a while a protank or evod needs a tiny bit of tinkering to make contact.

Either that or slightly pry the post up on the MVP. I use a steak knife.

 

[erikbal]

I had this same issue with my evod and just pried the pin ever so slightly with a small flat head screw driver and that took care of it. I'd rather try that first before I pry on the MVP itself.

Sent from my DROID4 using Tapatalk

 

[CreepyLady]

I had this same issue with my evod and just pried the pin ever so slightly with a small flat head screw driver and that took care of it. I'd rather try that first before I pry on the MVP itself.

Sent from my DROID4 using Tapatalk

This ^^^^^

 

[Tinkiegrrl]

I've had that happen with one particular iClear 16. Just one for some reason though. So, I used tweezers on the clearo rather then mess with the MVP 2

 

[Archer]

Thank you all so much! What a great site.

 

[MD_Boater]

The same thing will happen in a mini pro tank 2 if the coil is not screwed all the way into the base. It keeps the pin on the bottom of the tank too high up to make contact. Might be true for a full size pro tank, too...