Innokin MVP 2.0 + Aspire Nautlius Glassomizer - Somethings wrong ...

[Previse]

Hi guys,

I just received my aspire naut + innokin MVP 2.0 in the mail and set them up. Any of the flavors i try (From the sampler pack) all taste the same. Non minty + dull. I'm not sure if its my settings or the actual juice....

Voltage + wattage are set to
3.3 + 6.0 respectevly.

With a 1.8 OHM head on. when i press the P and U button for 3 seconds i see
A: 2.0
U: 4.2

Am i messing something up? I'm so confused ..

Thanks.

 

[edyle]

Get the wattage up to about 8 watts.

Or get the voltage up to 4 volts.

 

[Previse]

Get the wattage up to about 8 watts.

Or get the voltage up to 4 volts.

Should i do both or one or the other?

 

[Baditude]

You can't adjust both. You are either in voltage (U) or wattage (P) mode. Voltage and wattage work together and you pretty much get the same results, different ways to get to the destination. But, when you make adjustments with the wattage (P) you'll remain in wattage mode. Likewise, if you make adjustments with the voltage (U), you'll then be in just voltage mode.

Pressing both the U & P buttons simultaneously will give you the atomizer coils resistance in ohms. For example: A 2.0

Then the battery voltage will be displayed.

 

[edyle]

The nominal voltage of a lithium battery is 3.7 volts, so as a rule of thumb you could start at that voltage and it should at least "work".

3.3 volts is definitely on the low side; plus with the nautilus, it comes with dual coils so it's really intended for higher power vaping.