Innokin SVD firing pin?

[espada]

Hi all,

My SVD seems to have a problem recently. Whenever I tried to fit my protank 2 onto it, it sort of "reject" my protank by pushing it out. I just cant seem to be able to screw my protank into it. (Its works perfectly a few months back.)

Protank works perfectly with my MVP v2 though.

As I tend to use fogger v3 with my SVD, I didn't realise this until recently.

I have tried screwing Iclear30 onto the SVD as well, Able to screw in with a bit of strength (able to feel the "rejection" though).

SVD Threading gone wrong? Firing pin protrude too much? Cant seem to figure out whats wrong. Been reading up but seems like I'm the only one with this problem

Advise?

 

[espada]

No one Knows?

 

[retired1]

Sounds as if your center pin is sticking out more than it should. Does the center pin and o-ring seal appear intact in the well?

 

[espada]

Sounds as if your center pin is sticking out more than it should. Does the center pin and o-ring seal appear intact in the well?

yes it does! All intact! However, the center pin seems to be spring-loaded, meaning I'm able to push it down.. Is that normal?