Io6 on a Reo

Status
Not open for further replies.

six

Vaping Master
ECF Veteran
Verified Member
Feb 17, 2011
3,706
4,504
under the blue sky
I used i06's for a few months on my REOs. No problems... but one difference. I used a grateful vaper sleeve on mine which allowed me to use 510 drip tips. This creates a little more distance between your mouth and the atty and also seems to generate a little more pressure when drawing air through the atty. That results in being able to run the atty wetter without it seeming flooded and juice doesn't escape between the sleeve and the atty like it does with the plastic i06 tips -- It makes it act a lot more like a 510 barrel atty.
 
Last edited:

nerak

ECF Guru
ECF Veteran
Verified Member
Feb 12, 2011
25,335
60,415
Fairfield Township, OH, USA
www.facebook.com
I only used the blind squonk with the i06. It takes a very small amount of juice at each squonk. I think the drawing and squonking pulls the juice up much better.

They worked well and were one of my favorite atomizers.

If you vape a few times after squonking then it should not leak out juice when you set it down.
 

steven445

Super Member
ECF Veteran
Verified Member
Nov 24, 2012
548
694
34
Ohio
I only used the blind squonk with the i06. It takes a very small amount of juice at each squonk. I think the drawing and squonking pulls the juice up much better.

They worked well and were one of my favorite atomizers.

If you vape a few times after squonking then it should not leak out juice when you set it down.

Hmm maybe I should try the blind squonk.
I have the grateful Vapor sleeve and when I squonk the juice just runs out of the atomizer sleeve.
 

Justice

ECF Guru
ECF Veteran
Verified Member
Mar 10, 2011
13,472
29,170
52
The part of Canada that doesn't get enuf Snow :(
I Like my Rm2 a lot and I got pretty good at it but Bobas just does not vape good in a RBA.
I tried everything and it just burnt every wick and every coil within hours!
I have to use the disposable attys for Bobas unless someone has some suggestions to make it work in a RM2?

Simply your not getting your wick wet. I'd almost guess your wick is too tight. Loosen it off and try it. If not that try some ekowool you can't burn it.
 

steven445

Super Member
ECF Veteran
Verified Member
Nov 24, 2012
548
694
34
Ohio
Simply your not getting your wick wet. I'd almost guess your wick is too tight. Loosen it off and try it. If not that try some ekowool you can't burn it.

I use a micro coil for all my coils and put in either cotton or XC 132.
I squonked a lot to make sure it was wet but maybe I need to squonk even more often.
Also I was making coils that were like 1.5 ohms.
Maybe I need like 1.8 ohms to maybe 2 ohms.
 
Status
Not open for further replies.

Users who are viewing this thread