Ipv D2 not working properly

Status
Not open for further replies.

Aemlus

Full Member
Verified Member
Oct 15, 2015
38
7
Vapers Haven
Turned on my ipv d2 and came to this screen. Pressing the fire button after that turns off the screen and pressing other buttons wont work. Tried tightening the 510 connector and replacing new batteries and still the same results. Had not leaked into my mod before and im sure im not pressing or holding on to any buttons when im inserting the battery. Really need help thanks
cb0046062f115e2186c2d365478e03b5.jpg
 

suprtrkr

ECF Guru
ECF Veteran
Verified Member
Jun 22, 2014
10,410
15,048
Cowtown, USA. Where the West begins.
I don't have that mod, but what the screen is telling you is the installed chip (SX130) and the firmware version (3.4). It may have bricked, unfortunately. It is supposed to show that when it cold boots, but it ought to move on from there as the electronics fire up. It may be bringing up the update app and porting the mod into your computer would allow updating or reinstalling the firmware. But I am not an expert on this mod or the chip, so bump for an answer.
 
Status
Not open for further replies.

Users who are viewing this thread