IPV mini: Using 2 different batteries: Efest 3100mah IMR 20A 18650, Spny VTC4 18650 2100MAH 30A

[Ozzybozzy]

I have a broken ipv mini and Im trying to figure out the problem.

So my question is can to different batteries have and effect on issues related to box mods. They are both 18650 btw?

I switch between these batteries when it gets empty

 

[CampbellMC]

It really shouldn't give you any problems. Battery mixing is only an issue in the dual 18650 mods. Not sure how they are set up, but check to see if the spring is in good condition and the bottom cap is as well, sometimes people get juice gunked up on components and it wont make a proper connection.

 

[Ozzybozzy]

I really dont think any juice got in the conenction Imreally careful about that and my lemo doesnt leake in the under deck where the condense build up I always wipe the lemo, the connection dont have any condense.

But I noticed my sony vtc4 had some condense inside the wrap whivh in my opinion somes from the heat it dissapates it is right at the bottom close to the vending holes of the battery cap