I am currently running a 35 amp efest on my ipv v2. I am using it on a zenith clone built to 1.3 ohms. When I hit this device, the battery reading will go down to nothing left but it will still fire. After I let up on the button, the battery goes back to normal. And I can only hit it at 50w for about 2-3 seconds without it saying check battery. Don't kno if this is normal or not. Any help would be great!
Ipv v2 battery reading problems
- Thread starter Zaagy
- Start date
- th_trl_thread_readers 0
- Status
I run a 1.5 ohm setup on my IPV2 the battery will drain to 25% when I press the button when I put in one of my fresh efest 35a mine does pretty much the same thing yours does sans the check battery. Might just be the fact that its stepping up so much voltage that its messing with the internals, thats just an uneducated guess though. I do notice that when hit mine @ 50W it drops down to 43W because it cant go past 8.5V
- Status
