Ipv3 li resistance problems help

[Lmunro97]

So ive had the ipv3 li for about two weeks and i use kanthal a1 22 gague to build my coil i try to build it out to .2 ohms i have a ogm meter to test it but once i put it on my ipv3 li it always reads like .32 or .44 or it jumps around everytime i hit it why does it do this? Is there a way to lock the resistance in so it wont jump around? Please helpp

 

[Ou2mame]

Are the screws that hold your coil leads tight enough?

 

[Lmunro97]

Yes i believe so, every time i hit it or it heats up the ohms resistance will jump around.

 

[Dale Freed]

I am not too sure about this but with the sigelei 150 the higher you go in wattage the accuracy of your build declines. Perhaps that is part of the issue. I Ou2 may have a point as well, I noticed that if the coils on the center post/s are not lined up properly or sitting on top of each other, wattage variation can occur.