Im using the IPV3 with a Mutation v2 rda. Both of my batteries are fully charged to 100%. Whenever I try to vape it, it says "Check Bat" even though I have a full charge. Could this be the coils? I dont know why its doing this because it was working fine earlier.
What brand name & amp rating batteries?
The IPV3 requires a minimum of 2 matched/ married 20a CDR batteries, 2 matched 30a CDR better for low ohm high watt.
The protective circuitry of the regulated mod is probably kicking in because your coil's resistance is too low. Consider the "check batteries" as an error code that the resistance is too high of an amp load for the batteries or you've reached the processor's amp limit.
found out the issue. I currently have two 20amp batteries and a 25amp battery. It would not run with both 20amp batteries but when I put in the 25amp, it would run up to 150w.
You need to be sure to use identical batteries, and that the batteries are "married" - always used together. Otherwise, the weaker battery will self-destruct.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.