Ipv4s help pls

[Philipus95]

OK so I've had my Ipv4s for about 6 months now, everything has worked fine until yesterday. Suddenly it started firing and didn't stop, so I pulled the batteries out as quick as I could. When I put the batteries back in it gave me a screen "YH SX330 V4S T 12.9" while this message is on my screen I can't do anything. so I looked it up, some people said to update the firmware, so I attempted to do so. Unfortunately the program said it could not find the device. At this point I was tired, so I just went to bed. When I woke up the next morning I popped the batteries in and it turned on fine. But later that day the auto firing happened again, as with the screen.

If anyone has any advice I would greatly appreciate it.

FYI I tried pressing all the buttons on the device. As well as using fully charged batteries.

 

[classwife]

Moved this to Temperature Control from Ask The Veterans - you need help now...not in a few days.

 

[Philipus95]

Moved this to Temperature Control from Ask The Veterans - you need help now...not in a few days.

OK thanks

 

[Shigura]

It's been awhile since I've used this same device with no issue. But as far as updating firmware is concerned make sure you take out the batteries and try again.

Although I'm not sure a firmware update will fix the issue. It's possible a leaky atomizer might of been it's downfall.

 

[Philipus95]

It's been awhile since I've used this same device with no issue. But as far as updating firmware is concerned make sure you take out the batteries and try again.

Although I'm not sure a firmware update will fix the issue. It's possible a leaky atomizer might of been it's downfall.

I had my batteries out, it won't let me install the driver, it brings me to box for options and it's just blank