Is it me or the mod?
- Thread starter Hotbox147
- Start date
- th_trl_thread_readers 0
- Status
Thanks. I figured that's what I would have to do. Can I use the other two in my Sigelei 150TC or separately in a single 18650 mod?
I believe you can still use the other two as a married pair, I can't see why you wouldn't be able to as they have both been charged and discharged together. Separately yeah of course you can. I'm no battery expert but like I said I can't see any reason as to why you can't use the remaining two as a married pair still.
Have you installed the latest firmware update ?
No not yet. Didn't even know there was one until you posted it. Have you?
As long as your battery's are getting discharged @ the same rate (different mods with discharge @ different end rates) of one another, if one battery gets a higher discharge and you try to "merry" the three again, one may be weaker and will lower the amps from the weaker one defeating the purpose ...........
Last edited:
I'll update my rx200 when I get in later, I'm currently at work with no computer on site. Seems there is another rx200 update as of yesterday
yerp unfortunately i'm using mechs and i have to swap batts once or twice a day depending on how i'm feeling, what i'm craving, what juice mg i'm using and what resistance i'm at... i love seeing vendor's tout "this 18650 mech mod will last you TWO DAYS of OUTSTANDING vaping!!!!" pfft, yeah right. If your going to BS me about battery life what else would you be willing to BS about? s&h time? BSx3.
It should be noted that brand new batteries need to be cycled about 8-10 times before they reach there full potential, they need sort of a break in period to get up to speed.
I run VCT4s and .18 ohm builds and I have ti USB charge it every night. I probably dont have to but do it anyway. Im vaping dual claptons in an AeolusV2 and the atty and the mod are getting too hot. I need to make some adjustments for this slab of a mod.
Just updated, easy UI and display etc. Just need to get better with understanding temp control haha.
I actually take mine down to where the batt bar flashes! All cells still reading about 3.3/3.4! I also go until my IPV4s won't fire before I change batts in it! No issues with those batts in Over 8 months of use! I know, I know this is probably not the best for the batts but I trust my devices safeties and have never felt my batts even get a little warm! Heck most of the time the outside of my devices are a little warm from my hands but the batts are still cool to the touch! I'm by no means suggesting that everybody should do this just letting you know what has worked for me so far! Please always vape within your comfort zone!
Mr. Coyote
All of our electronic/mechanical devices are designed to function perfectly throughout a lifetime of use.
Our stringent quality control processes insure that a defective product can never reach the customer.
Careful investigation by our warranty department has determined that any problems with our products are the direct result of user error, or intentional misuse.
Sincerely.
Acme Novelty Company
All of our electronic/mechanical devices are designed to function perfectly throughout a lifetime of use.
Our stringent quality control processes insure that a defective product can never reach the customer.
Careful investigation by our warranty department has determined that any problems with our products are the direct result of user error, or intentional misuse.
Sincerely.
Acme Novelty Company
- Status
Similar threads
- Locked
