Is there a difference between the TS3 and Evod/Protank coil heads?

[Racehorse]

Not sure what to buy.

I have both clearomizers, are the coils interchangeable?

Also, if they are different, how are they difference, can somebody tell me how I tell them apart? This is the reason I don't like to have different stuff, cuz \i never know what goes w/what (bad eyesight these days!)

Photos would be great~!

 

[zeroclue]

The heads are Ok to use on all the clearomizer you have. The centre post might be different lengths.

There is tiny gold writing on the side telling you the ohms if you buy different ones but its difficult to see

 

[erikbal]

From what I remember I think you can use T3s coils in the evods but not evod coils in the T3s. I'm not SURE on this, so let's wait for someone who knows for sure.

Sent from my DROID4 using Tapatalk

 

[Racehorse]

From what I remember I think you can use T3s coils in the evods but not evod coils in the T3s.

I think you are right. I'll wait and see if anyone confirms this.

Reason for not having more than ONE kind of clearomizer, cuz some of this gets confusing and I don't want to remember what goes with what.

 

[DavidOck]

In general, T3S heads will work in the the Evods/PT1, 2, Aro1 and many other single bottom coil toppers.

The collar at the base of the head is a smaller diameter on the T3S style than it is on the PT/Evod ones, so it will fit down in the body. Not all manufacturers run to the same tolerances, so there may be occasional issues with connection. When that's the case, sometimes wiggling the center post of the head down a little from the grommet can fix that. Just a tiny bit, you don't want to pull it out!

 

[Racehorse]

thanks David! Will test all that today.

 

[Choc_Addic]

I'm using RC200 BCC clearos (my daily driver) and rebuilding coils. So I have not been buying replacement coils lately.

But all the coils I have are from my old T3s, protank, protank mini and EVOD's. They all work fine for me. I sometimes have a connection problem but a little closer look and tweak (like DavidOck said above) usually fix it.

Good luck.

 

[tick22]

I have a old Protank 2 that does not take the newer heads and I think the old short stem heads that the old evods used. They are a smaller stem and smaller air hole. any chance anyone knows who still sells them? If there another type coil like the t-3s or MT3 that will will fit?? All my EVOD coils are too thick.

 

[DavidOck]

You aren't trying to put the new dual coil heads in it, are you? They won't go. Many places still carry the single coil ones.

Here's one good place to start: http://www.discountvapers.com/kanger-replacement-coil-heads/

Just use their chart to make sure you get the right ones