Hi everyone, its been awhile since I checked in ECF. I finally took the plung into RBAs. I was wondering if there is an guide on the forum about how to wrap a coil with different wire gauges to get the ohm you are looking for.
Is there a ohm guide
- Thread starter rob33
- Start date
- th_trl_thread_readers 0
- Status
I'v seen a thread somewhere here i think it was in rebuildable atomizers part of the forum where people were posting coil's, id and's ohm's
But you still need a meter to check your coil's before you use them
But you still need a meter to check your coil's before you use them
I suggest reading the stickies in the Rebuildable Forum (the top of the page where this topic is listed). I'll brb with the names of the threads.
- Status
Similar threads
