Issue with Kanger T2

[sfshadow]

Hey all! I recently received a Kanger T2 that I'm using with an Volt X2 900 mah battery and this morning it just stopped working. The battery began to blink so at first I thought the battery just needed to charge but after I took the battery off the charger the batt still blinked with the T2. To test out the batt I threw on a CE3 and Mini Viva Nova and both worked perfectly so I ruled out the battery as the cause. I even tried changing out the coil head on the T2 but that didn't make a difference. I'm assuming something shorted out on the T2? I was starting to like this clearomizer but I was hoping to get more than a couple of days out of it. Any ideas on what's causing it to short out like this? Thanks.

 

[txtumbleweed]

Hey all! I recently received a Kanger T2 that I'm using with an Volt X2 900 mah battery and this morning it just stopped working. The battery began to blink so at first I thought the battery just needed to charge but after I took the battery off the charger the batt still blinked with the T2. To test out the batt I threw on a CE3 and Mini Viva Nova and both worked perfectly so I ruled out the battery as the cause. I even tried changing out the coil head on the T2 but that didn't make a difference. I'm assuming something shorted out on the T2? I was starting to like this clearomizer but I was hoping to get more than a couple of days out of it. Any ideas on what's causing it to short out like this? Thanks.

It is probably not making good contact being as the T2 is not made for 808 X2 batteries they are hit and miss when you use them together.

 

[crxess]

Just pulled my T2 off the Ego to take a look. You might try pulling the center pin down just a touch with needle nose pliers and see if that helps. Also make sure the connections are clean. Q-tip and alcohol.

 

[sfshadow]

Thanks for the input. I tried pulling the connector pin out a touch and now things are working smoothly again.