Issues switching Atlantis between mech and DNA 30

Status
Not open for further replies.

logistixz

Full Member
Verified Member
Dec 28, 2014
30
1
Virginia
Hey guys first post here. Just curious if there is something going on with what I'm currently using.

First off, I've been using a mech mod (lancelot clone w/aspire atlantis tank efest 18650 20a) and I recently picked up a cloupor dna 30. I've never had an issue using the atlantis on the mech but just switched it to the dna 30 and noticed it seems to run hot even at 20 watts. I started getting a burnt taste and thought maybe the atomizer got fried but switched it back to the mech and it was fine, no burnt taste.

Ideas?
 

huckleberry

Full Member
Verified Member
Oct 4, 2014
58
41
Dublin, Pa
If your running the .5 ohm coil in the atlantis the cloupor dna 30 wont fire it with a regulated wattage setting. It will just bypass the chip and use the voltage from the battery. It's basically a mech mod on low ohm builds. Not sure why it would run hotter than your lancelot, maybe it has more voltage drop then your cloupor.
 

logistixz

Full Member
Verified Member
Dec 28, 2014
30
1
Virginia
Makes sense now.

So I actually tried it again and from doing a little research it looks like it won't regulate when firing below 4 volts. It stopped giving me a burnt taste running the atlantis at 20w but once I cranked it up to 28w and it was firing at 4 volts I got the burnt taste again and dropped it back to 20w and the taste was gone.

Burnt out atomizer?
 
Makes sense now.

So I actually tried it again and from doing a little research it looks like it won't regulate when firing below 4 volts. It stopped giving me a burnt taste running the atlantis at 20w but once I cranked it up to 28w and it was firing at 4 volts I got the burnt taste again and dropped it back to 20w and the taste was gone.

Burnt out atomizer?


i also use a atlantis on a cloupor 30w device. i run it on 30watts with no issues, did u already try a new coil?
 

Sthur

Vaping Master
ECF Veteran
Verified Member
Aug 14, 2013
3,160
978
Denver
Ditto to above, I run my Atlantis on my cloupor at 30 watts and just great vape. You have the holes open? I would use the 2nd largest or largest if you prefer more airy draw.

Lastly when you screw on the tank after filling make sure your not blocking the juice holes with the bell or you will go dry faster or burnt. Make sure all 4 are clearly seen in through the glass.
 
Status
Not open for further replies.

Users who are viewing this thread