Issues with nautilus + BVC

[Siochanai]

Been having some issues with my nautilus and bvc setup today. Just came ine yesturday and having issues getting performance. I primed the coil with five drops and let it sit. Then filled the tank and let it sit over night. Staryed vaping at 10 watts on my rDNA and eased it up to 12.5 watts which is 5 volts. Having issues finding a sweet spot. Lung hits are okay but seem to lead to flooding. Mouth to lung hits are leading to flooding. Now I am having an issue clearing out the gurgle might have to take it apart. Not sure what I did wrong it was vaping good for a few mills now it is all acting up again. Any tips or tricks to get a smooth operation? I prefur lung hits but this device seems to flood fast doing that wide open. At higher wattages. For me 14.5 -15 seems to be the sweet spot but cant go that high. I like a warm hot vape. This is my first clero i normally use a rda but sucks to drip at work all the time.

 

[Towmotor]

On my Provari I never took the Naut above 4.5 volts, I dont use it on my RDNA30
I dont prime the BVC's, I found that lead to gurgling and unsatisfactory performance.
Make sure the tank is not over tight.

 

[scottkh]

I had that same problem with mine. turns out i wasnt getting a good seal around the top of the glass at the chimney. Make sure the top is properly tightened as well and check the silicone as well

 

[maraud]

Yeah the top seems to be with most problems come from. It likes to unscrew itself when you're tightening the base.

 

[Siochanai]

Well i cleaned it all out and the gurgle is gone. This time I did not prime the coil just let it sit and saturate for 30 min. Seems to be working great now. Just need to figure out how to hit the thing now...

 

[Mrdaputer]

I never put drops on the coil. Nor start out at 10 watts. I fill the tank tighten just snug let sit or a while. Turn the volts down low. Do a couple of primer puffs then enjoy. after a bit I kick the watts up a little at a time, Then bam sweet spot

 

[Siochanai]

I have a vaporshark rDNA only goes down to 7 and it flashes my ohms reasing when I go below 10 watts. Still fires but do not want to cause accidental damage to it. Seems to be going good so far up to 13 watts no gurgle or flooding. Sonce I tore it apart. Tried 14.5 watts and chaind lung hits into a nasty dry hit so turned it down to 13 droped airholes and trying mouth to lung. Flavor is great mouth to lung but i suck at mouth to lung. Sadly chain vaping this thing with lung hits is asking for a dry hit.