istick 30w + iclear30b

[ronk77]

Hi, I have been using a iclear 30b tank for awhile and I like it quite well. I recently bought a istick 30w, when purchased I was told my iclear 30b tank would need to be screwed into the ego adapter that came with the istick. rather then screwed directly into the istick. it just looks like a pice of metal to me, so i wanted to confirm if this is true or not.


Thanks

 

[bobwho77]

If I recall correctly, the 30b has 510 threads. It shouldn't have to have the eGo adapter

 

[Maiar]

Hmm. From what I recall the 30b is a 510 tank... it's got the little screwy part sticking out of the bottom? It shouldn't need the adapter.
It's this guy right?

 

[ronk77]

it does have 510 threads and will screw in without the adapter, I was told when screwed directly in (rather then into the adapter) the istick would burn out the coil on the iclear. I just took her word for it, but after putting it all together the adapter just looks like a piece of metal. I dont see anything special about it that would change how it works or why it would matter if I used the adapter or not.

EDIT: she told me a non sub-ohm tank screwed directly in will burn up the coils. seemed suspicious to me so I'm asking here.

 

[Susan~S]

EDIT: she told me a non sub-ohm tank screwed directly in will burn up the coils. seemed suspicious to me so I'm asking here.

She was wrong. You do not need the adapter. The only way you could get "dry hits" would be if you vaped at too high of a power level.

The rule of thumb for EVERY vape device you'll ever own is the same (when running in power or wattage/voltage mode). Turn your voltage/wattage down, take a few hits, bump it up, couple more hits. Repeat until you find your "sweet spot". If it starts to taste funny, gets too hot or tastes burnt, back it down. Different flavors will have different sweet spots so you just have to experiment.

 

[Two_Bears]

Hi, I have been using a iclear 30b tank for awhile and I like it quite well. I recently bought a istick 30w, when purchased I was told my iclear 30b tank would need to be screwed into the ego adapter that came with the istick. rather then screwed directly into the istick. it just looks like a pice of metal to me, so i wanted to confirm if this is true or not.


Thanks

If it has ego threads instead of a 510 pin in the bittom of tge tank then yes you MUST use tge ego adapter.

 

[ronk77]

Thanks for the reply's, I thought what I was told didn't make a lot of sense but wanted to be sure.