itaste mvp 2.0 and rda

[razr1221]

I tried installing an rda on my mod but all it does when i press the button is light up and will not fire up the coil. What could be wrong?

 

[djsvapour]

Is it a dual coil? Have you tested it on a multimeter?

It's either too low resistance or you have a short.

 

[Susan~S]

Hello and welcome to the forum razr1221. Glad to have you here!

What is the resistance of your build?

 

[drunkenbatman]

I tried installing an rda on my mod but all it does when i press the button is light up and will not fire up the coil. What could be wrong?

Hey mate, first of all, welcome!

Second of all, with the RDA on the MVP, press and hold the two buttons on the front. It should give a number, what is it?

Third of all, what is the RDA you're trying to use?

Fourth of all, did you build the coil init?

 

[Dextrose]

Hello and welcome to ECF Razr, i find on my mvp 2 the pin is not spring loaded, you may want to take a small flat head screw driver and pull the pin up a bit so it makes contact with the RDA you are using, if you click the 2 buttons together it will give you a number if it shows non then you might want to try that, hope it helps, Happy vaping

 

[razr1221]

Hey mate, first of all, welcome!

Second of all, with the RDA on the MVP, press and hold the two buttons on the front. It should give a number, what is it?

Third of all, what is the RDA you're trying to use?

Fourth of all, did you build the coil init?

I don't currently have the rda with me. Im stuck at guard drill. My current setup is a kanger tank. It reads a 1.8 and works fine. The rda is a panzer with a single coil. My friend who got me into vaping made the coil and installed it.

 

[CassiusCloud]

Sometimes that gasket on the tank terminal can get squished and not make connection on my MVP but will work fine on other mods..

If you're getting a resistance reading of 0.0 on your mvp with this tank, but it's working fine on other mods..It could be the terminal on the MVP needs to be raised up,or the gasket on the tank is squished too much to make contact..

It happens with my kanger T3'd tanks all the time..
i'll have them on my v3 vv's and then go to put them on my mvp and realize i tightened it too much on my v3 vv..

 

[razr1221]

Thanks i will try the suggested solutions when i get home and let you know what worked

 

[CassiusCloud]

Also open up the tank and see if the coil is loose or not. Sometimes they can unscrew and come loose a little when you go to refill them..

 

[juicynoos]

Has the rda worked on your mvp at all since your friend made the coil up for ya? If so, the coil may just be loose from heat as is quite common. Also, do you have a multimeter or ohms reader so you can check the rda off the mod?