iTaste MVP V2 Coil recommendation/help

[onestepaway]

Hi, yesterday I bought the mvp2 with a nimbus clone to get myself back into vaping and such, i know the mvp2 has a 3amp limit so could anyone reccomend a build to me that would run pretty well

had a 0.8 ohm dual coil running yesterday at 7w which comes out at just under the limit

Getting the caravela clone next week with some vtc's so will be doing sub ohm dragons

Thanks in advance
Richard

 

[State O' Flux]

Hi, yesterday I bought the mvp2 with a nimbus clone to get myself back into vaping and such, i know the mvp2 has a 3amp limit so could anyone reccomend a build to me that would run pretty well

Even though many MVP2s will fire sub-ohm with varying degrees of success... I find that rebuildables on MVP2s, tend to work best at the suggested "soft" resistance limit of 1.3Ω+/-.

On the (very) rare occasion that I put a dripper or rba on an MVP2, I will go to just below to 1.2Ω+/-, which pretty much "pegs the meter" for wattage (11w) and current (3a), without, I would imagine, applying any serious undue stress to the amp limiter circuit.

Using cotton... 8/9 (5/64" or 2.0mm mandrel) ~ 10/11 (1/16" or 1.5mm mandrel) wraps of compressed 28 gauge will get you there.

YMMV ;-)

 

[onestepaway]

Thanks bud