Joyetech Ultimo Heads - TCR settings

[xabbu]

dear all, I'm using the Ultimo on my different mods (cuboid, VTC Dual, ...) with the genius myEvic firmware by clockselect (highly recommended).

Now I'm asking for some help and hints to use the TCR modes I never tried before. What are the correct settings for the three different coils, which are available for the Joyetech Ultimo:

MG Ceramic 0.5 ohm
MG Clapton 0.5 ohm

and the

MG QCS 0.25 ohm

Can I use these coils with TCR? What values do I have to edit?

in case this might be important, I'm vaping Heisenberg 55/45 with 4mg nicotin and a flavour-concentration about 12-13 percent.

Please excuse any misspelling, as a non native speaker I'm constantly fighting against the German autocorrection here... ;-)

thx in advance

Chris

 

[Eskie]

Well, the ceramics leaked on me so I never played with them very much, and recently I haven't used the tank much. IIRC, I ran the rewickable notch coil as SS and it worked well. Without knowing precisely what SS is used (they never say, or at least I couldn't find it) my usual default is 316L with a TCR of 92, but I guess you could just go with the default SS on the Pico and see how it vapes. I do not believe either the ceramic or Clapton are SS so power only on those.

There is an Ultimo thread on here you can search for and check what others experiences have been.