Juggernaut - How to drill out the second hole

[Devilok]

Hi everyone:

I apologize if this has already been discussed, I did some searching and could not find an answer so figured I'd post something here. I recently received a Juggernaut, and I would like to drill out the second air hole. Can anyone tell me how to do this i.e. what type of drill bit (I have a toolkit at home that has a cordless drill and drill bits, but I wasn't sure if I needed a special type of drill bit, I am not that handy of a guy lol). I will be out today so figured if I knew I could stop over to Lowes and pick up what I need. Thanks for any tips or suggestions!

 

[Mbisjr]

If your going to lowes, pick up a cobalt drill bit, it will cut nicely. Mine went smooth

 

[Mbisjr]

By the way, take your time and don't put a lot of pressure on the bit. Allow it to cut on its own.

 

[Devilok]

Thank you very much, I am headed to Lowes tonight and give it a go! Did you cut yours 1.5mm?

By the way, take your time and don't put a lot of pressure on the bit. Allow it to cut on its own.

 

[Mbisjr]

Thank you very much, I am headed to Lowes tonight and give it a go! Did you cut yours 1.5mm?

Yup, I drilled both holes 1/16 drill bit (1.58 mm)

 

[Devilok]

Went to Lowes tonight and picked up a 1/16 cobalt drill bit, got home and it drilled through that second hole like butter. Love the draw now, just perfect! Thanks again for the tip worked great

Sent from my DROID RAZR using Xparent Purple Tapatalk 2

 

[Mbisjr]

What kind of wick and coil set are u using

 

[Devilok]

I'm currently using 28g Kanthal, 4 wraps, 400 mesh solid wick

Sent from my DROID RAZR using Xparent Purple Tapatalk 2