since i started dripping, juice has been coming up the drip tip...is this normal or am i doing something wrong?
Juice comes up drip tip
- Thread starter TheVapingNinja
- Start date
- th_trl_thread_readers 0
- Status
I had the same problem after buying my first rebuild-ables this weekend . Use less (in my case WAY less) cotton. I started having success building single "micro" coils only in my Igo-w. Im using VV mods (provari and MVP 2) so im not really chasing low ohm coil builds. I started positioning my coils as close to the air hole as possible w/out touching and shorting the coil to the side of the Igo. I usually un-roll/cut an inch (if not less)of cotton, tear that in half lengthwise, get it kinda snug in the coil, then trim enough so there isn't much hanging over the edge of my Igo-W deck. I then spread/loosen the ends so they aren't twisted anymore and kinda frayed out. Finally, I use a tiny flat-head screwdriver to tuck the rest to fill in space on the deck.
This has been working VERY well for my after a bunch of failed attempts over the weekend. Im getting the best Vapor prodution and taste out of my juices I've ever had... which is only 2 months, lol! Good luck, hope this helps! PS: I got all this info by searching the threads on this forum and trail and error!
This has been working VERY well for my after a bunch of failed attempts over the weekend. Im getting the best Vapor prodution and taste out of my juices I've ever had... which is only 2 months, lol! Good luck, hope this helps! PS: I got all this info by searching the threads on this forum and trail and error!
How many drips are you using? I tend to "prime" with 3-4 directly on the coil and cotton, then test fire before putting the cap on. Then its never more than 4-6. I flooded the hell out of my first few builds and constantly got a mouthful of juice (exaggeration!). Coil position (Im talking right near the air hole in the cap) and cotton (spread out after twisting to get in the coil) made me successful. Im by no means an expert, but after following a few tips I read on here lead me to a much better build process for dripping. I feel your pain cause this was me 48 hours ago for sure! What Mod are you using? Are you building dual coils? What Ohm's?
This drip tip solves that problem.
$3.01 Stainless Steel Curved Drip Tip for 510 / ViVi Nova / DCT at FastTech - Worldwide Free Shipping
$3.01 Stainless Steel Curved Drip Tip for 510 / ViVi Nova / DCT at FastTech - Worldwide Free Shipping
yeah the only times ive had juice go up the dt is when the DT was small or the coil is raised quite high or sitting under the DT... sorry cant help... you must just have strong lungs lol can you see through walls to?
looks like a tube from a hamster water bottle
looks like a tube from a hamster water bottle
looks like a tube from a hamster water bottle
Well all I know is a buddy uses it and swears by it and he owns about $3000 worth of high end mods, tips and tanks.
Don't get me wrong, I'm not knocking it.. if it works or looks good on a mod that great but I had to get the hamster bottle thing in cus that was the first thing I thought as soon as I saw it
I think I saw the lady at the local vape shop with a pipe mod and something like that.. it looked coolhahaa ha supereddie
- Status
Similar threads
