Just Crazy?
- Thread starter Strangebrew
- Start date
- th_trl_thread_readers 0
- Status
I had a similar thought just recently, kind of the way inkjet printers work, but I think as of right now, the setup you'll need to make it work would be way too big and would zap batteries like there's no tomorrow...
How about using a laser to vaporize the liquid? There are lots of laser pointers now available that can bore a hole through plastic or light up a match.
Not necessarily. A laptop lcd screen inverter with a CCFL backlight has an input of 5v DC and outputs around 1100 v AC.
Last edited:
getting high voltages is actually very easy, inductor will attempt to maintain the amount of current coursing through it no matter what so if you for example charged one up with 1 amp passing through and then suddenly hiked the resistance in series to a bazillion then the inductor will produce(as long as it has charge) the required voltages to overcome that resistance no matter how much it takes. The real issue is with insulation, since the discharge will take the route of least resistance it would be very difficult to get the arc going where you want it
Last edited:
You should do a bit of research about Spark Gap. HV Discharge release Ozone , that will burn your lung and its HIGHLY toxic. Just make a simple spark gap and run it for like 15 sec , you will smell the ozone.
Best Regards,
Eric
- Status
