Just Ordered my first atomizers !

Status
Not open for further replies.

DancingHeretik

Dancing in the Chaos
ECF Veteran
Verified Member
Mar 20, 2011
8,837
62,105
San Antonio, TX
You chose what's probably the most popular resistance and type of atty. But, they run too hot to me. I need 2.0 ohm or higher.

So, all I can say is to make sure to start with very low voltage, just in case. If you're like most people, you'll love it.

Ooooh, a red drip-tip! That's one of the things I love about the 306 . . . . . drip-tip colors that can be mixed and matched with battery colors.
 

NoMoreMarbs

Senior Member
ECF Veteran
Verified Member
Dec 10, 2012
176
47
Maple Grove MN
You chose what's probably the most popular resistance and type of atty. But, they run too hot to me. I need 2.0 ohm or higher.

So, all I can say is to make sure to start with very low voltage, just in case. If you're like most people, you'll love it.

Ooooh, a red drip-tip! That's one of the things I love about the 306 . . . . . drip-tip colors that can be mixed and matched with battery colors.

The Voltage on my battery is 3.7 Hopefully thats ok for these
 

DancingHeretik

Dancing in the Chaos
ECF Veteran
Verified Member
Mar 20, 2011
8,837
62,105
San Antonio, TX
An atomizer might last a couple of weeks or for several months. All you can do is take good care of it and see. Keep it wet while you're using it, keep it clean and un-gunked, and cross your fingers.

3.7 would be too high for me. But, like I said, I can't handle the lower ohm, hotter atties that others love. So, just give it a try.
 

DancingHeretik

Dancing in the Chaos
ECF Veteran
Verified Member
Mar 20, 2011
8,837
62,105
San Antonio, TX
A normal atomizer has a bridge and a wick over the coil. Some people rave about how much better they are with the bridge and wick removed. So much so that they even make some atomizers that are made without a bridge in the first place.

I don't happen to like them. But, a lot of people do.
 
Status
Not open for further replies.

Users who are viewing this thread