Kabuki 510 - will refilling it get any easier over time?

[DrTron]

Hi Guys,

I recently bought a Kabuki 510 and love it. It does have a few, say, areas of improvement. I can only open (and close) the tank by using the allen key - the rubber seal is way too tight to screw on by hand (and the base has some really sharp edges).

Does that get any better over time? I have seen no improvement over the ~20 tanks I've vaped. And yes, i do lubricate the seal with Glycerine every time.

Besides, that tiny plastic piece at the battery contact (the stud screw makes the contact between atomizer and battery as far as I can see) can be improved too - it fell out a couple of times already. I personally would have warm-pressed a bit of plastic with a stainless steel pin in the middle into it - about the same way you mount ball bearings...

Cheers,
Tron

 

[NotSoMini]

Join us on the Kabuki thread for any help you need. Anybody Using A Kabuki?

 

[DrTron]

Thanks, I'll contribute there, then. Somehow I didn't find this thread beforehand, but didn't expect it to be in section "Forum Suppliers - ProVape", either, rather than the "Tank" section...