Kangaroo sub tank mini leaks

Status
Not open for further replies.

UncleMike

Senior Member
ECF Veteran
Feb 15, 2015
191
159
Nova Scotia
Remove your tank from the istick. Remove the base from the kanger subtank mini and also the drip tip from the tank and set it aside. You may be able to save any e liquid in your tank if it's not too old. Once you've emptied the tank, grip the glass and pull it down off of the metal part that holds the drip tip. Give them both a good cleaning in warm running water and then dry them off with a paper towel. Take a look at the seals on the metal part where then glass slides on. Sometimes one of the O-rings (seals) gets put on inside out or sometimes they've even been switched from top to bottom. The bottom seal should be slightly wider and you should notice the flat side of the o-ring facing outward so that it makes a good seal with the glass. Now, remove your coil from the base and hold it in a paper towel and blow the extra fluid out. Do the same thing with the base. While it's apart check the contact pin on the bottom of the base to make sure it's not pushed out too far. Once it's fully cleaned, screw the coil back into the base, make sure it's snug but don't overtighten. Slide the glass back on the metal part and make sure it seals tightly. You can use a small bit of e-liquid to wipe on the O-rings to make the glass slide on easier. Once it's together, refill your tank and while holding it upside down screw on the base. Put your drip tip (mouth piece) back in the tank and take a few pulls on it to reprime the coil. Now screw the tank back on the istick and give it a go. Hope this helps.
 
  • Like
Reactions: dcfluegel
Status
Not open for further replies.

Users who are viewing this thread