Kanger dual coil unit rebuild with clapton

[m4licious]

Hello everyone!
I have seen many videos and tutorials on how to rebuild the old kanger dual coil, but it seems that they use a non-clapton wire. Because i am new to this(rebuilding coils) i wanna ask if is possible to rebuild this little coil with clapton wire. Will it be harmful to an ego battery(650mah)? Any help would be appreciated! Thanks a lot.

Below is the coil that i mean:

 

[93gc40]

Possible yes... go on a need a really small clapton though.. 30 core with 40 wrap...

Would work best in the dual coil heads as a single verticle coil.

I used to do triple twisted builds un those heads. So you could do a clapton if you can get it small enough.... other issue is going to be the legs and getting good contact in the 510 without damaging the insulator.

Sent from my SCH-I605 using Tapatalk

 

[m4licious]

Thanks for answering!
I will try that when i get the clapton. However, i did try to rebuild the coil with a kanthal 0.254 wire. The truth is that i dont get much vapor and taste than the default kanger one. First i did 7 wraps with inner hole being 2mm and the vapor production was awful. Then i did 11 wraps, with the inner hole of the coil being 1mm and i got more close to the default one. Should i try again with more wraps and with a lower inner hole(say .5 mm)? Thanks again!

 

[ChelsB]

Would one need to strip the legs of the Clapton's outer wire in order for the grommet and pin to seat correctly?


Sent from my iPhone using Tapatalk