Hi everyone I have a question. Not new to vaping but new to this type of tank and and cartomizer. I have a problem, recently I started to get a gurgly sound in my carto and so I replaced it thinking that was the problem. Took the tank apart, cleaned everything out, and pu in a new carto only to take about maybe a total of 10 draws through it before it started to gurgle and not hit anymore. What could be causing this. Any help would be great.
Kanger EVOD problem
- Thread starter bigmac801
- Start date
- th_trl_thread_readers 0
-
- Tags
- evod revolution
- Status
Is it it low on liquid? Try topping off with liguid see if that helps. You can also run a Kleenex thru the mouthpiece there could be liquid in the stem.
Welcome to ECF , but putting more juice in it , will probably not solve your problem . There are several things that can cause gurgling , and then , failure to work > Either your drawing the vapor too hard , or your juice is real thin , Say all PG , or close to it . Using too low of voltage or wattage . Doing that will not vaporize the juice you have drawn into the coil . Thus gurgling , and after it's flooded , probably won't fire very well either . Good Luck .
EVOD's are notorious for that gurgling. I have found that if I keep it over half full it stops the gurgling. Hope this helps.
Mine gurgles from time to time as well. I usually take it apart and clean it. I also cmake sure no juice on battery and then fill it. Past half and it works fine
When you get low on juice it will gurgle due to the evod working on a vacuum principle
It only takes one person to start a revolution.
It only takes one person to start a revolution.
I had the same problem with mine at first too. I let it sit for a while and it worked again. But it's a possibility that you got 2 beat carto's as well.
- Status
Similar threads
