Kanger M-T3 issues

[feign]

Using a brand new Kanger M-T3 with a 2.2(2.4?)ohm coil, Gotvapes 17mg Flux Cake Supreme liquid (70/30 mix, I think?) on an eGo-T 1000mAh battery at 3.3v.

It is leaking into the connection portion of the eGo.

I am smoking it like a Vision V2 (the one with replaceable coil) and I'm wondering if that's the problem (tilting).

Am I doing something wrong? Seriously two pulls and there is liquid all in the battery. The Kanger T2 I have is amazing and I am having no issues with that one at all.

Help!

 

[steeledragon78]

i have several mt3's and havent had that problem, except once when i didnt screw the base in all the way. you may have a bum head on it. ive vaped mine at almost horizontal (almost parallel with the floor) and only had a slight gurgle from time to time(after getting my initial gurgle issue resolved)

 

[Mad Scientist]

There are a few things than can result in a leaking T3. Right off the bat, start with a full tank. When the tank is less than about 1/3 full, there's a risk of not having enough neg pressure in the tank to hold the juice. Check that everything is properly tight. Make sure you are getting a good seal between the silicone gasket at the top of the wick assembly and the tank tube.