Kanger Ni200 Coil Problems

[LukeR]

I bought a 5 pack of the Ni200 coils and they're all coming up at about .25 ohms on all my devices and not even close to .15. Wouldn't bother but I keep getting real hot/dry burnt hits. Anyone else ever have this happen? What could cause it?

 

[Eitje]

You sure you locked in the base resistance each time you changed the coil? (Assuming you vaping in TC mode since its ni200 coils)

 

[LukeR]

You sure you locked in the base resistance each time you changed the coil? (Assuming you vaping in TC mode since its ni200 coils)

Yep! Brand new coil each time first time putting the tank on the mod and shows up .25

 

[SpaceApe]

Maybe you got a few bum coils out of the batch?

 

[Eitje]

Yep! Brand new coil each time first time putting the tank on the mod and shows up .25

Sorry to keep pressing the obvious but it will keep showing .25 unless you lock in a new resistance. (A lot of TC mods show the locked in resistance in TC mode, not the measured value unless you press the fire button)
You sure you locked in a new base resistance either by pressing +&- or up&down or a similar key combi?

 

[LukeR]

Sorry to keep pressing the obvious but it will keep showing .25 unless you lock in a new resistance. (A lot of TC mods show the locked in resistance in TC mode, not the measured value unless you press the fire button)
You sure you locked in a new base resistance either by pressing +&- or up&down or a similar key combi?

Hey no problem I appreciate the help! I'll double check that though to be on the safe side!