Kanger Subtank Mini RDA Draw ?

[sorrynomore]

Hello,
I've been off the cancer sticks for one year now Woo Hoo!
I just got me a Subtank mini figuring it'd be a little bigger for making coils with the rda part than the evods and PT minis I've been using up until now and it is.

I like a cool vape @ around 5.6 watts into a 2 or so ohm coil which worked out fantastic with the evods and PT minis.I made my first coil for the subtank @2.2 ohms, 9 wraps 30 gauge kanthal with an inner diameter of 2.4mm and find the draw too airy even at the smallest air setting.My question is if I were to increase the inner diameter of the coil would that help tighten up the draw abit.I'm not into the high watts thing,I just want to stay off the siggies.Oh I am using an ipv mini too.

Any assistance would be appreciated

Thanks

 

[Puff2K]

Hi, I don't have an answer, just want to say congratulations! And bumping up your post so others can chime in.

 

[RandyF]

Easiest way would be to find a drip tip with a small inner diameter that would give you the draw you are looking for.

 

[ktez71]

Easiest way would be to find a drip tip with a small inner diameter that would give you the draw you are looking for.

I second this! That's what I did with mine and it works just the way I like it now. I just got a couple of the cheap plastic drip tips and now it is perfect.

 

[tehmidcap]

You can always set it in between settings too -- It won't lock and you may have to fix it from time to time but you can set it to say half of the one small hole (or any portion of the wide open hole). Or, like others said, use a standard (not wide bore) drip tip. It does make a difference.

 

[stvn77]

this happen to me too
+1 to try another drip tip

to me is like learning curve... i was using a aerotank, so i felt the subtank so airy...
the past week i was using the buddha mini and after 2 weeks no using the subtank i just felt it right

 

[BigEgo]

Also you can use the cyclops airflow and adjust the airflow as small as you can make it. Should be a bit smaller than the 1 airhole.

 

[sorrynomore]

Thanks All...
I've slapped on the smallest holed drip tip I have and set the air flow controller to only a partial hole and it's better but still a tad airy.
I may have set the coil a tad high.above the air hole.When I have abit of time I'll make another coil,maybe 3mm inner diameter and set it down a wee bit lower.

Thanks Again!

 

[sorrynomore]

I thought I'd update...
Well,I spun a 2.9mm coil 7 wraps of 30g. Kanthal set it a little lower between the posts,it came out to 2.1 ohms,it works great,I've even got the air flow dial set to the second from the lowest setting and the draw is pretty much just the way I like it.

 

[zoiDman]

I thought I'd update...
Well,I spun a 2.9mm coil 7 wraps of 30g. Kanthal set it a little lower between the posts,it came out to 2.1 ohms,it works great,I've even got the air flow dial set to the second from the lowest setting and the draw is pretty much just the way I like it.

Just Curious.

Have you ever tried Nichrome 80 to make your coils?

 

[sorrynomore]

Just Curious.

Have you ever tried Nichrome 80 to make your coils?

As of yet,no.