Kanger T3 Questions

[crzyhrse99]

Hey everybody looking for some info on the T3's from people with experience, just a few questions before I order a few.

1. About how many tanks can you guys go through on a single atomizer head before it starts not giving the flavor you want or no throat hit etc., and are you using PG,VG or mixed. And if youre using a VV device, about what voltage?

2. Seems like (and I could be very wrong) this should probably be used with one juice only as it stores juice in the cylinder chamber when the tank is empty.

3. And if you are switching juices, is it pretty straight forward as say a vivi nova?

4. Lastly, just give youre overall opinion. Things you like, don't like, is it good quality setup and reliability. Thanks

 

[Unforeseen]

Moved to Clearomizers

 

[Susaz]

I had a first batch of heads that failed, but this new batch has been working flawlessly. 17 days without a glitch, I wash with hot water whenever I'm changing juices, and every now and again I put it in alcohol overnight and dry burn. Depending on the ohm of the head and the liquid, I'm vaping at 3.7/4.2 volts on 1.8 ohm heads. Cylinder chamber? Get a pipe cleaner and run through the chimney every two or three days to get rid of any lingering odors. Yesterday I had a few dry hits that I solved sucking without operating the battery and lowering the voltage. It's more straightforward than the Vivi to me... If I have half a tank and my head is dirty, I just change the head without touching the liquid. On the vivi, you have to open it fully to get the head out... I'm vaping 40PG/60VG without any problems and vapes almost to the lower rim with very little gurgling (when the juice level gets about the lower grommet, some juice does seep in the breathing tube and I think that's what makes it gurgle... If you like bottom coils you'll love the T3... Mind you, buy the T3 from one vendor and replacement heads from another. Not all batches are equal

 

[Kayo]

FYI I've just notice a difference with the threading on my T3s. I felt like I was sucking in air while using the one on the left and sure enough I was! I was switching between a MT3 and the T3 on the left when I noticed it. My MT3 has the same threading as the two T3s on the right and I DID NOT have any problem with it whatsoever.

I am using the MT3 and T3s on a genuine eGo Twist.

 

[crzyhrse99]

Thanks for the feedback guys! Have been reading the long T3 thread so i'm learning some more.