Kanger T3S atty question

[steeledragon78]

So im hoping this is in the right place, if i got it wrong mods i apologize. For those of you who dont know the T3S is a clearo with a replaceable atty in a manner similar to the Pro-tank and Evod. i picked up a handfull because sunvapor was running a special that if you bought a 5 pack you got a free baseplate. i have had them for about a week and im liking them, to a point. my old atties were a full base replacement type where baseplate and atty were one unit. they were easy to rewick and fairly easy to clean, but burnt alot of my fave juices so i wanted something else. after a week with the T3S type i dont seem to need to rewick as often, but they seem to burn the juice more often than the old type. /bg

so my question is has anyone else had similar issues or have any advice for better enjoyment. they are all 2.5 Ohm attys on a Vamo 2 running between 3 and 4.5 watts. i dont dare go much higher as they burn quicker at higher wattage. Oh and the juice is Halo Longhorn, and Nicquid Chery on top.

 

[sonicdsl]

Moved to Clearomizers

 

[lynch]

They are sold out now but discount vapers has them cheaper Kanger MT3s Base Replacement
And the coil heads are $5.96 for a 5 pack . Not a sale just everyday low prices !
http://www.discountvapers.com/kanger-t3-coil-heads/

 

[yotasavg]

I too went for the sun-vapers deal before anyone else had them listed, but DV is the hook up all the time! I have had good luck with these heads so far. I'm actually using these heads in my T3S, EVOD and ProTanks, all with EVOD center tubes. I get the occasional burnt taste, but it always goes away and I get nice, warm, clean vapor. I'm about ready to give cotton balls a try. I used to use cotton in my single piece T3 heads and it was phenomenal compared to the silica. One last thought, if you're getting a lot of burnt hits with these, take out a flavor wick and give it a shot!