Kanger T3S

[cigga]

I'm new to this as well and I have only used the same model as well, with no problems that I can tell so far, but as I said, not much experience for comparison purposes.

 

[texasguy4]

I use Protanks, MT3S's, and Evods, like them all, but only after rebuilding with 2 ohm micro coils ans cotton wicks.

 

[Trev1]

If you want a mini T3 wouldn't that be the evod? Just sayin'....I love all my Kanger products including my evod battery. I have two knock off eGo batteries and the authentic evod is better. Maybe it is regulated, I don't know. The others hit hard at first and I can get burnt taste it not careful. Not so with the evod battery.

If you have leaking issues after cleaning the heads, make sure you tightened the heads very well. That has been my problem along the way. I think I am just afeerd of overtightening.

I do love my vision victory 5ml bcc. However, it won't fit on my ZMax (?). Good, cheap clearo IMO.

Agreed my Evod is my go to vape BUT IMO there is a flavor difference my evod gives off a pungent condensed stale vape when my tank is about 4 days in without cleaning and on the same head (vaping fruity stuff)....while as with the T3s it has a more cleaner tast to me for some reason mainly in part because of the more airey draw but still it's a more crisp clean vape...

As far as my heads ....I almost over tighten ...I feel that between the condensation and juice build up in the tip and center tube once it drips and floods down the center coil it's time to take apart and blow each piece out...which sucks but I do it...IMO the evod is worth a on the go look and feel when not home...

T3 Minis - on sale!

Thanks for this..but a minit3s would be more helpful since I have a nice amount of heads for them...the t3 base is not fun to rebuild and they are a bit more pricey on some sites...but much thx !


ANY INPUT ON THIS GUYS...?
I bought a geniune protank about 2-3 mths ago and always had several connection issues but not toooo bad...out of nowhere my connector head is shot it has to be tilted and turned to stay connected and catch a thread ...if it even stays on...it will on my vamo and sigeli 13b but won't on any egos ...also it seems no matter how hard I try even with a new head within a hour my juice taste burnt if to high in watts ....I'm using a vamo on 8-9 watts or 4 volts with a bottle of 50/50 America red white and blue lemonade ejuice from MBV....I think I'm gonna give this protank away and I bought the new protank yesterday...I hear great stuff about the protank but for me ...I'm waiting for a wow

 

[szot]

Don't care much for the MT3's....had some arrive with bad coils which I had to replace....also they are very airy for me..and I don't like the many mouthfuls of juice and gurgling, and the leaking bottom seals that seem to occur very often...also I don't like the bottom fill even using a tip needle.....I guess I've always preferred top fillers clearos and a lil warmer taste with no problems..

 

[Jagermyster]

I have been using for about 2 weeks so far so good had some burt taste when i switch fluid out>

 

[italianjoe69]

I have been using a T3S for a few days and love it. I had a leaking issue yesterday but found out the coil was not screwed down all the way into the base. Gotta make sure those gaskets seal!!!

For those looking for a 'mini' T3S here you go:

discountvapers.com - Kanger Mini T3S

I have this and an MT3S on the way. I figure the metal on the MT3S will keep it from getting ruined if in a bag and the mini is just more portable.

 

[jrenae4]

I also have a T3S en route and now will order this mini one as well. Hope it works great

 

[Jagermyster]

I have been using the Kanger T3s for about 1 month now and I have found that if you tighten the battery to much it will cause a slow leak. This is due to the battery push up slightly on the att.... Anybody else have tips/tricks for the kanger