kanger vs aspire

Status
Not open for further replies.

javarivanhans

Full Member
Jan 24, 2015
42
21
Houston, TX
I have both the PT3 mini and K1. Both are great. PT3M is low capacity but easier to clean between flavor changes, but its tip is small and limited . K1 looks sharper IMO but not as easy to clean out if u change flavors a lot, it can use more different drip tips and coils are easier to find IMO.

In the end I gave away my PT3m and ordered a bunch of K1s for my personal taste tester collection of favorite flavors.
 

motherofhavok

Full Member
Feb 15, 2015
22
5
Kansas
I didn't like my mini Protank3 at all. For me, it was way too airy, didn't give me much flavor, and both the atomizer coil and mouthpiece got way too hot, way too fast. I took it back in a few days. My B&M switched it out for an EVOD 2. That one was pretty nice, but I was going through coils every other day. Those two products were worse than the cheap plastic clearomizers I had bought from the gas station. I ended up getting an Aspire ET-BVC, and love it. It is styled like the EVOD 2, but holds more and carries flavor so much better.

I haven't enjoyed my Kangertech products, nor have I liked their coils in my husband's Davide, but they get so many high reviews, I can't help but wonder if I just haven't found the right Kanger for me. Personally, I'm on the Aspire camp.

But, I second the recommendation to get an AeroTank instead of a ProTank 2 or 3. The airflow adjustment might just be the key to getting a satisfying vape out of those coils. It'll probably do you better in the long run.
 

djsvapour

ECF Guru
ECF Veteran
Oct 2, 2012
11,822
7,901
England and Wales
For me, the mini Protank 3 was the worst tank of the entire family.

The dual coils made it a weak vape compared to the mPT 1 and 2.
The coils lasted about the same as all those 'old' Kanger heads, which was barely more than 48 hours.
It gurgled unless I ran it a high power, then it burnt.

The K1 is a medium performer, not up there with Nautilus BVC, but acceptable.
The coils last over a week, easy.
Does it leak and gurgle....?

MPT3, Evod2 and TS3D were the worst tanks Kanger ever made.
 

dashreeve

Senior Member
ECF Veteran
Feb 4, 2014
145
150
Florida
I didn't like my mini Protank3 at all. For me, it was way too airy, didn't give me much flavor, and both the atomizer coil and mouthpiece got way too hot, way too fast. I took it back in a few days. My B&M switched it out for an EVOD 2. That one was pretty nice, but I was going through coils every other day. Those two products were worse than the cheap plastic clearomizers I had bought from the gas station. I ended up getting an Aspire ET-BVC, and love it. It is styled like the EVOD 2, but holds more and carries flavor so much better.

I haven't enjoyed my Kangertech products, nor have I liked their coils in my husband's Davide, but they get so many high reviews, I can't help but wonder if I just haven't found the right Kanger for me. Personally, I'm on the Aspire camp.

But, I second the recommendation to get an AeroTank instead of a ProTank 2 or 3. The airflow adjustment might just be the key to getting a satisfying vape out of those coils. It'll probably do you better in the long run.

Same for me, I have the pro tank mini 2 and the 3, the 2 I like much better. Even better than that is my pro tank 2 (not mini). Even better than that is my lemo :)
 

Jovey

Super Member
Jan 24, 2015
326
521
within my own thoughts....
I'm leaning toward the aerotank mini for my next tank...however, i've noticed that it sometimes may need the 510 to [eGo] Adapter for certain mods. I vape an Innokin iTaste MVP 2.0, so would i need the adapter?

As for selections of tanks, i absolutely love my Nautilus mini tank...not sure if that would fit your eGo, but it's worth looking into, but like the others have stated...don't think you can go wrong with the Kanger Aerotank and/or the GS Air...which is also on my list of top tanks to purchase.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread